Kyocera FS-1020D Operation Manual page 82

Printed Results
Characters out of position.
Table 3-2 (Continued)
Corrective Action
Check the file or program.
Check whether the problem is being caused by a
PRESCRIBE command error. If the problem occurs only
with a specific file or program, the most likely cause is an
error in a parameter to a command or command syntax.
Check the paper size setting.
Check that the paper size set in the paper source and the
paper size set on the KM-NET Remote Operation Panel
are the same. (See section
Chapter 4)
and
3-5
Print Quality Problems
1.4.5 Paper Size on page 1-23