Brother FAX-2820 Service Manual page 196

(10) Video signal reception
Code 1 Code 2
A0 03
A0 11
A0 12
A0 13
A0 14
A0 15
A0 16
A0 17
A0 18
A0 19
A0 20
A8 01
A9 01
(11) General communications-related
Code 1 Code 2
B0 02
B0 03
B0 04
BF 01
BF 02
BF 03
* Establishment of FAX communication:
FAX communication is established when the calling station receives a DIS (reception
capability) signal from the called station and the called station receives an NSS or DCS
(communications test) signal from the calling station.
(12) Maintenance mode
Code 1 Code 2
E0 01
E0 02
(13) Equipment error
Code 1 Code 2
FF X X
Error correction sequence not terminated even at the final
transmission speed for fallback.
Receive buffer empty. (5-second time-out)
Receive buffer full during operation except receiving into
memory.
Decoding error continued on 500 lines.
Decoding error continued for 10 seconds.
Time-out: 13 seconds or more for one-line transmission.
RTC not found and carrier OFF signal detected for 6 seconds.
RTC found but no command detected for 60 seconds.
Receive buffer full during receiving into memory.
No video data to be sent
Unable to continue to receive color FAX (Remaining ink
insufficient)
RTN, PIN, or ERR received at the calling terminal. *
RTN, PIN, or ERR received at the called terminal. *
Unable to receive the next-page data.
Unable to receive polling even during turn-around transmission
due to call reservation.
PC interface error.
Communication canceled by pressing the Stop/Exit before
establishment of FAX communication*.
Communication canceled by pressing the Stop/Exit after
establishment of FAX communication*.
Transmission canceled due to a scanning error caused by no
document or document feed problem in ADF scanning in real time
transmission.
Failed to detect 1300 Hz signal in burn-in operation.
Failed to detect PB signals in burn-in operation.
Equipment error (For X X, refer to
9 - 1 5
Causes
* Available in German models only
Causes
Causes
Causes
Section 9.1.1 [ 2 ].)
Confidential