Fine Adjustment Of Scan Start/End Positions (Function Mode 54) - Brother FAX-2820 Service Manual

8.4.11 Fine Adjustment of Scan Start/End Positions (Function code 54)
Function
This function is to adjust the scan start/end positions.
Operating Procedure
(1) Press the 5 and 4 keys in this order in the initial stage of the maintenance mode.
The "SCAN START ADJ." will appear on the LCD.
(2) Press the 1 or 2 key to display the present compensation level for the start position.
Compensation levels can be adjusted in 11 steps from –5 to +5 (mm).
(3) Press the
Press the Stop/Exit key, and the machine returns to the initial state of the maintenance
mode without adjusting compensation levels.
(4) Press the Menu/Set key.
The "ACCEPTED" will appear on the LCD. One second later, the machine returns to
the initial stage of the maintenance mode.
NOTE: The correlation between the scan start/end positions and compensation levels is
shown next page.
key to increase compensation levels, and the
8 - 1 9
key to lower them.
Confidential