Schwinn 245 Owner's Manual page 36

Condition/Problem
Console shuts off (enters
sleep mode) while in use
Unit rocks/does not sit
level
Pedals loose/unit difficult
to pedal
Clicking sound when
pedaling
Seat post movement
36
Things to Check
Check electrical (wall)
outlet
Check connection at rear
of unit
Check data cable integrity
Check data cable
connections/orientation
Reset Machine
Check magnet position
(requires shroud removal)
Check Speed Sensor
Check leveler adjustment
Check surface under unit
Check pedal to crank arm
connection
Check crank arm to axle
connection
Check pedal to crank arm
connection
Check locking pin
Check adjustment knob
Make sure unit is plugged into a functioning wall outlet.
Connection should be secure and undamaged. Replace adapter
or connection at unit if either are damaged.
All wires in the cable should be intact. If any are cut or crimped,
replace cable.
Be sure cable is connected securely and oriented properly. Small
latch on connector should line up and snap into place.
Unplug unit from electrical outlet for 3 minutes. Reconnect to
outlet.
Magnet should be in place on pulley.
Contact Customer Care for further
assistance.
Adjust levelers until bike is level.
Adjustment may not be able to compensate for extremely uneven
surfaces. Move bike to level area.
Pedal should be tightened securely to crank. Ensure connection
is not cross-threaded.
Crank should be tightened securely to axle. Be sure cranks are
connected at
180 degrees from each other.
Remove pedals and reattach.
Be sure adjustment pin is locked into one of the seat post adjust-
ment holes.
Be sure knob is securely tightened.
Solution