Schwinn a25 Owner's Manual page 26

Console shuts off (enters
sleep mode) while in use
Unit rocks/does not sit
level
Pedals loose/unit difficult
to pedal
Clicking sound when
pedaling
Seat post movement
26
Check RPM Sensor (requires
shroud removal)
Check data cable integrity
Check data cable
connections/orientation
Reset machine
If bike has batteries, check
Battery Level icon on console
or check batteries.
Check magnet position (re-
quires shroud removal)
Check RPM Sensor
Check leveler adjustment
Check surface under unit
Check pedal to crank
connection
Check crank to axle
connection
Check pedal to crank
connection
Check locking pin
Check adjustment knob
RPM sensor should be aligned with magnet and con-
nected to data cable. Realign sensor if necessary.
Replace if there is any damage to the sensor or the con-
necting wire.
All wires in the cable should be intact. If any are cut or
crimped, replace cable.
Be sure cable is connected securely and oriented prop-
erly. Small latch on connector should line up and snap
into place.
Unplug unit from electrical outlet for 3 minutes. Recon-
nect to outlet.
If the battery level shows low or no power, replace the
batteries.
Magnet should be in place on pulley.
Contact Customer Care for further assistance.
Leveling feet may be turned in or out to level bike.
Adjustment may not be able to compensate for extreme-
ly uneven surfaces. Move bike to level area.
Pedal should be tightened securely to crank. Be sure
connection is not cross-threaded.
Crank should be tightened securely to axle.
Remove pedals and reattach fully.
Be sure adjustment pin is locked into one of the seat
post adjustment holes.
Be sure knob is securely tightened.