Reset The Zyxel Device To Its Factory Defaults - ZyXEL Communications P-660HW-Tx v3 User Manual

Chapter 23 Troubleshooting
2 Restart the ZyXEL Device.
3 If the problem continues, contact your ISP.

23.4 Reset the ZyXEL Device to Its Factory Defaults

If you reset the ZyXEL Device, you lose all of the changes you have made. The ZyXEL
Device re-loads its default settings, and the password resets to 1234. You have to make all of
your changes again.
You will lose all of your changes when you push the RESET button.
To reset the ZyXEL Device,
1 Make sure the POWER LED is on and not blinking.
2 ress and hold the RESET button for five to ten seconds. Release the RESET button
P
when the POWER LED begins to blink. The default settings have been restored.
If the ZyXEL Device restarts automatically, wait for the ZyXEL Device to finish restarting,
and log in to the web configurator. The admin password is "1234".
If the ZyXEL Device does not restart automatically,
Device's power. Then, follow the directions above again.
284
sconnect and reconnect the ZyXEL
di
P-660HW-Tx v3 User's Guide