Advertisement
Available languages
Available languages
Ports and buttons
Front panel
LAN1 - Gateway default IP:
LAN2 - Gateway default IP:
RES Reset switch
Rear panel
Operating voltage
On/Off switch
Connection for 230V power cord
DCL Internal data clock
Resetting the device to its factory settings
To reset the gateway to its factory settings, press the reset button RES until the
PWR LED flashes red. After about 2 minutes, the gateway will be operational again
and can be set up again.
L
NOTE
Resetting interrupts all ongoing telephone calls and Internet connections. If a
custom configuration was set up on the gateway, this will be lost on resetting the
device to its factory settings. Consequently, please save the custom configuration
via the user interface before resetting the device. You can then reload the confi-
guration into the device later. Use a ballpoint pen or something similar to press the
reset switch.
192.168.100.1
192.168.200.1
USB ports (2 x USB Host 2.0)
WAN2 (ETH) Connection of external modem (WANoE)
WAN1 (VDSL/ADSL) DSL connection
S
1 - S
4 ISDN ports
0
0
(RJ-45 sockets and 4 clamps)
FSC Internal frame clock
LED indicator for operating mode
(master/slave) when cascading
EN
©2017
| 13
Advertisement
Chapters
