Table of Contents
Advertisement
6 . Troubleshooting
6. Troubleshooting
Problem
No image
The projector
that you want
to connect to
is nowhere
to be found
on the list
of available
projectors
Can't
communicate
The projected
image is
rather slow
compared to
that of the PC
(continued on next page)
6
Likely Cause
The projector is not turned
on.
The projector's input source
isn't switched to MIU.
The PC and/or projector's
network settings are not
configured correctly.
Weak radio signal
The Projector isn't in Live
Mode
The projector isn't capable
of relaying dynamic images
such as PowerPoint®
animation at full speed.
"Optimize Performance" is
set to "Image quality".
Things to Check
Is the projector's lamp on?
Is the projector switched to
MIU?
Check both the PC and
projector's network settings.
If you change the projector'
s settings, turn off the
projector's AC power and
then turn it on again. If you
simply put the projector in
STANDBY power mode and
then turn it on again, the
new settings might not take
effect.
• Bring the PC and projector
closer together
• Radio waves won't go
through concrete and
metal (steel doors, etc.)
Check the mode on MIU
Menu to make sure that it is
in the correct mode.
Try increasing the Capture
Performance priority level.
It may improve the speed a
little.
Try setting "Optimize
Performance" to
"Transmission speed".
* User's Manual (detailed) - Operating Guide
Reference
Page
Number
*6
*7
0
–
53
58
58
Advertisement
Table of Contents
