Resetting - Mercedes-Benz GLK-Class Operator's Manual

Sliding sunroof
92
Opening and closing
Overhead control panel
To open
:
To open
;
To close
=
Turn the SmartKey to position 1 or 2 in the
X
ignition lock.
Press or pull the 3 switch in the
X
corresponding direction.
i
If you press the 3 switch beyond the
point of resistance, an automatic opening/
closing process is started in the
corresponding direction. You can stop
automatic operation by operating the
switch again.
Resetting the sliding sunroof and the
roller sunblinds
Reset the sliding sunroof and the roller
sunblinds if the sliding sunroof or the roller
sunblinds do not move smoothly.
Turn the SmartKey to position 1 or 2 in the
X
ignition lock.
Press the 3 button to the point of
X
resistance in the direction of arrow ; until
the sliding sunroof is open approximately
4 in (10 cm).
Pull the 3 switch repeatedly to the point
X
of resistance in the direction of arrow =
until the sliding sunroof is fully closed.
Keep the 3 switch pulled for an
X
additional second.
Press the 3 button to the point of
X
resistance in the direction of arrow ; until
the roller sunblinds are open approximately
4 in (10 cm).
Pull the 3 switch repeatedly to the point
X
of resistance in the direction of arrow =
until the roller sunblinds are fully closed.
Keep the 3 switch pulled for an
X
additional second.
Make sure that the sliding sunroof and the
X
roller sunblinds can be fully opened and
closed again ( page 91).
Y
If this is not the case, repeat the steps
X
above again.
! If the sliding sunroof and the roller
sunblinds cannot be fully opened or closed
after resetting, contact a qualified
specialist workshop.
Problems with the sliding sunroof
Problem: the sunroof cannot be closed
and you cannot see the cause.
G
WARNING
If you close the sliding sunroof again
immediately after it has been blocked or
reset, the sliding sunroof closes with
increased or maximum force. The reversing
feature is then not active. Parts of the body
could be trapped in the closing area in the
process. This poses an increased risk of injury
or even fatal injury.
Make sure that no parts of the body are in the
closing area.
If somebody becomes trapped:
release the switch immediately, or
R
during automatic operation, push the
R
switch briefly in any direction
The closing process is stopped.