Floormats - Mercedes-Benz GLK-Class Operator's Manual

Push a round pen into opening
X
=( page 294) for approximately three
Y
seconds.
The zone currently selected appears in
compass display ;(
To select the zone: push a round pen into
X
opening =( page 294) until the desired
Y
zone is selected.
If, after a few seconds, the display in
compass display ;(
direction, the zone has been selected.
Calibrating the compass
Make sure that there is sufficient space for
X
you to drive in a circle without impeding
traffic.
In order to calibrate the compass correctly,
do the following:
calibrate the compass in the open and not
R
in the vicinity of steel structures or high-
voltage transmission lines.
switch off electrical consumers such as the
R
climate control, windshield wipers or rear
window defroster.
close all doors and the tailgate.
R
Switch on the ignition.
X
Push a round pen into opening
X
=( page 294) for approximately six
Y
seconds, until symbol
compass display ;(
Drive your vehicle in a full circle at
X
approximately 3 mph (5 km/h) to 6 mph
(10 km/h).
When the calibration has successfully been
completed, the current direction is shown
in compass display ;(
Floormat on the driver's side
G
WARNING
Objects in the driver's footwell can restrict the
pedal travel or obstruct a depressed pedal.
page 294).
Y
page 294) changes
Y
C is shown in
page 294).
Y
page 294).
Y
The operating and road safety of the vehicle
is jeopardized. There is a risk of an accident.
Make sure that all objects in the vehicle are
stowed correctly, and that they cannot enter
the driver's footwell. Install the floormats
securely and as specified in order to ensure
sufficient clearance for the pedals. Do not use
loose floormats.
Slide the seat backwards.
X
To install: place the floormat in the
X
footwell.
Press studs : onto retainers ;.
X
To remove: pull the floormat off
X
retainers ;.
Remove the floormat.
X
Features
295
Z