Cisco Linksys WAP300N User Manual page 141

Linksys WAP300N
How to set up wireless security
CAUTION
While in Wireless Bridge mode, this device can communicate with
other WAP300N devices only if they are also in Wireless Bridge mode
and the wireless settings are all identical
To set up wireless security for your WAP300N in Wireless Bridge mode:
Wireless > Wireless Security
1. Log into the browser-based utility (see "How to open the browser-based
utility" on page 8)
2. Click the Wireless tab, then click the Wireless Security page and select
the Security Mode (WPA2 Personal is recommended for most home
networks )
Depending on the security mode you selected, you may be asked to
enter additional information (see the following table)
Information
Security mode Required
WPA2 Personal,
Passphrase
WPA Personal
Encryption
WEP
Key 1
3. After you have entered all required information, click Save Settings
Description
Enter the passphrase of 8-63 characters
Select a level of WEP encryption, 40/64-
bit (10 hex digits) or 104/128-bit (26 hex
digits)
Enter the WEP key of your network Key
1 is the transmit key used by this device
Setting Up: Basics
18