How To Select Wireless Range Extender Mode - Cisco Linksys WAP300N User Manual

Linksys WAP300N
Depending on the security mode you select, you may be asked to enter
additional information Refer to the following table
Information
Security mode Required
WPA/WPA2
Passphrase
Personal
Encryption
Key 1
WEP
Authentication
5. Click Save Settings
Description
Enter the passphrase shared by this
device and your wireless router (or
access point)
Select a level of WEP encryption, 40 /
64-bit (10 hex digits) or 104 / 128-bit
(26 hex digits)
Enter the WEP key of your network
Key 1 is the transmit key used by this
device
The default is Auto, which allows
either open system or shared
key authentication to be used
Select Open to use open system
authentication (a WEP key is not used
for authentication) Select Shared to
use shared key authentication (a WEP
key is used for authentication)
How to use Wireless Range Extender
mode

How to select Wireless Range Extender mode

To select Wireless Range Extender mode:
Setup > Operation Mode
1. Log into the browser-based utility (see "How to open the browser-based
utility" on page 8)
2. Click the Setup tab, then click the Operation Mode page
3. Select Wireless Range Extender, then click Save Settings
Setting Up: Basics
15