Internet Port - NETGEAR JNR1010 User Manual

Internet Port

The Internet port section provides the following information:
MAC Address. The Media Access Control address, which is the unique physical address
•
used by the Internet (WAN) port of the router.
IP Address. The IP address used by the Internet (WAN) port of the router. If no address
•
is shown or the address is 0.0.0, the router cannot connect to the Internet.
Connection. This shows if the router is using a fixed IP address on the WAN. If the value
•
is DHCP Client, the router obtains an IP address dynamically from the ISP.
IP Subnet Mask. The IP subnet mask used by the Internet (WAN) port of the router.
•
Domain Name Server. The Domain Name Server addresses used by the router. A
•
Domain Name Server translates human-language URLs such as
IP addresses.
Show Statistics button. Click the Show Statistics button to display the following
•
screen:
The Show Statistics screen provides the following information:
System Up Time. The time elapsed since the router was last restarted.
•
Port. The statistics for the WAN (Internet) and LAN (Ethernet) ports. For each port,
•
the screen displays the following information:
Status. The link status of the port.
•
TxPkts. The number of packets transmitted on this port since reset or manual
•
clear.
RxPkts. The number of packets received on this port since reset or manual clear.
•
Collisions. The number of collisions on this port since reset or manual clear.
•
Tx B/s. The current transmission (outbound) bandwidth used on the WAN and
•
LAN ports.
Rx B/s. The current reception (inbound) bandwidth used on the WAN and LAN
•
ports.
Up Time. The time elapsed since this port acquired the link.
•
Poll Interval. The interval at which the statistics are updated in this screen. To
•
change the polling frequency, enter a time in seconds in the Poll Interval field, and
click Set Interval. To stop the polling entirely, click Stop.
N150 4-Port Wireless Router JNR1010
Administration
55
into
www.netgear.com