Prepared
Manfred Ortmann
Approved
2.2.10 Video Output
Pic. 212: Video output connector, X804
The video output 0 signals from the JADED are connected to connector X804, FTSH12501L
DV from Samtec, for direct interconnect to column and row drivers via LVTTL or RSDS from a
display.
Additional these signals are connected to the JADE Evaluation board connector X301 over 0
Ohm resistors. So the RGB interface 0 on the JADE Evaluation board can be used.
If the TCON interface will be used and the long connection to the JADE Evaluation board make
disruptions remove the 0 Ohm resistors.
On revision PA3 the pin 3 to 14 have another order.
Pin
1
2
3
4
5
6
7
8
9
10
11
Document Number
Checked
Date
20091005
Signal
GND
NC
DISP_N_R_11
DISP_P_R_11
DISP_N_R_10
DISP_P_R_10
DISP_N_R_9
DISP_P_R_9
DISP_N_R_7
DISP_P_R_7
DISP_N_R_5
Preliminary
Revision
Storage
PA 4.2
Mycable01
Function
Ground
Testpoint 801
DOUTB0_7
DOUTB0_6
DOUTB0_5
DOUTB0_4
DOUTB0_3
DOUTB0_2
DOUTG0_7
DOUTG0_6
DOUTG0_5
37(45)