Palm Rest - Dell Latitude D631 Service Manual

Back to Contents Page
Palm Rest
Dell™ Latitude™ D631 Service Manual
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface, such as a connector on the back of the computer.
1. Follow the instructions in Before You
2. Remove any installed media bay device (see
3. Remove the hinge cover (see
4. Remove the keyboard (see
5. Remove the display assembly (see
6. Disconnect the coin-cell battery from the system board (see
NOTE: You can leave the coin-cell battery in place (on the palm rest) unless you are installing a replacement palm rest, in which case you need to
remove the coin-cell battery and place it in the replacement palm rest.
7. Remove the three M2.5 x 8-mm screws labeled "P" from the top of the palm rest.
8. Turn the computer over and remove the hard drive (see
9. Loosen the two captive screws located at the front of the hard drive bay.
10. Remove the seven M2.5 x 8-mm screws from the bottom of the computer.
1 captive screws (2)
Begin.
Media Bay Devices).
Hinge Cover).
Removing the Keyboard).
Display Assembly).
Coin-Cell
Hard
Battery).
Drive).