Removing The Display Hinges - Dell Latitude D631 Service Manual
Hide thumbs
Also See for Latitude D631:
- User manual (184 pages) ,
- Quick reference manual (182 pages) ,
- Training (43 pages)
Table of Contents
Advertisement
7. Squeeze the flex cable release levers at either side of the top flex cable connector, releasing the connector.
1 top flex cable
2 flex cable release levers
connector
(2)
4 inverter board
5 bottom flex cable
connector
Removing the Display Hinges
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface, such as a connector on the back of the computer.
1. Follow the instructions in
Before You
2. Remove the display assembly (see
3. Remove the display bezel (see
4. Remove the display panel (see
5. Remove the M2.5 x 5-mm screw from the right display hinge.
1
M2.5 x 5-mm screw
2
4
alignment pin
6. Lift the right display hinge off the two alignment pins and out of the display back cover.
7. Repeat
step 5
and
step 6
for the left display hinge.
Back to Contents Page
3 back of display panel
6 pull tab on bottom flex cable
connector
Begin.
Display
Assembly).
Removing the Display
Bezel).
Removing the Display
Panel).
display hinges (2)
3
display back cover
(left and right)
Advertisement
Table of Contents
