Removing The Display Panel - Dell Latitude D631 Service Manual

1 screw covers/display bumpers (6)
4 display panel
4. Remove the six M2.5 x 5-mm shoulder screws from the front of the bezel.
NOTICE: Carefully separate the bezel from the display back cover to avoid damage to the bezel.
5. Starting from the inside edges of the bezel, use your fingers to pry the bezel upward and outward from the display panel. Release the sides of the bezel
next; if necessary, use a plastic scribe to release the corners of the bezel from the display panel.
NOTICE: To avoid damaging the computer when replacing the display bezel, ensure that the bezel edges line up with those on the display back cover,
and snap into place around the entire perimeter of the display back cover.
Removing the Display Panel
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface, such as a connector on the back of the computer.
1. Follow the instructions in Before You
2. Remove the display assembly (see
3. Remove the display bezel (see
4. Remove the three M2 x 3-mm screws from each side of the display panel.
1 display panel 2 M2 x 3-mm screws (6)
4 LED ribbon cable 5 bracket tabs (4)
2 M2.5 x 5-mm shoulder screws (6)
5 display back cover
Begin.
Display Assembly).
Removing the Display Bezel).
3 display back cover
3 display bezel