9. Turn the computer upside down with the back of the computer facing you.
10. From the back of the computer, remove the two M2.5 x 8-mm screws.
11. From the bottom of the computer, remove the two M2.5 x 8-mm screws labeled "D."
12. Turn the computer right-side up and open the display.
1
antenna cables (2)
13. Lift the display assembly out of the computer base.
Removing the Display Bezel
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface, such as a connector on the back of the computer.
1. Follow the instructions in
Before You
2. Remove the display assembly (see
3. Use a plastic scribe to pry the six rubber screw covers/display bumpers out of the screw holes on the front of the bezel.
2
display cable pull tab
Begin.
Display
Assembly).