Replacing The Display Panel; Removing The Display Panel Bracket - Dell Vostro 1200 Service Manual

2. Remove the display bezel (see
3. Remove the display panel (see
4. Remove the M2.5x5-mm screw.
5. Disconnect the inverter board.
6. Lift the inverter board out of the computer.
1 M2.5x5-mm screw 2 inverter board 3 inverter board connectors (2)
Replacing the Inverter Board
1. Place the inverter board inside the display bezel.
2. Attach the inverter board connector.
3. Replace M2.5x5-mm screw.
Replacing the Display Panel
1. Reconnect the top display-cable connector to the top flex-cable connector.
2. Reconnect the bottom flex-cable connector to the inverter connector.
3. Place the display panel inside the display back cover.
NOTE: The eight screw locations are numbered. Replace the screws in sequential order.
4. Replace the two M2.5x3-mm, the two M2.5x5-mm, and the four M2x3- mm screws in sequential order (two on each side of the display panel).
Removing the Display Panel Bracket
CAUTION: Before you begin the following procedure, follow the safety instructions in the Product Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on the computer.
1. Remove the display assembly (see
2. Remove the display bezel (see
3. Remove the display panel (see
4. Remove the M2x3-mm screws (two per side) from the display panel.
Removing the Display Bezel).
Removing the Display Panel).
Removing the Display Assembly).
Removing the Display Bezel).
Removing the Display Panel).