Ppp Interface Summary - ZyXEL Communications ZyWALL USG 1000 User Manual

Figure 252 Example: PPPoE/PPTP Interfaces
PPPoE/PPTP interfaces are similar to other interfaces in some ways. They have an
IP address, subnet mask, and gateway used to make routing decisions; they
restrict bandwidth and packet size; and they can verify the gateway is available.
There are two main differences between PPPoE/PPTP interfaces and other
interfaces.
• You must also configure an ISP account object for the PPPoE/PPTP interface to
use.
Each ISP account specifies the protocol (PPPoE or PPTP), as well as your ISP
account information. If you change ISPs later, you only have to create a new ISP
account, not a new PPPoE/PPTP interface. You should not have to change any
network policies.
• You do not set up the subnet mask or gateway.
PPPoE/PPTP interfaces are interfaces between the ZyWALL and only one
computer. Therefore, the subnet mask is always 255.255.255.255. In addition,
the ZyWALL always treats the ISP as a gateway.
At the time of writing, it is possible to set up the IP address of the gateway (ISP)
using CLI commands but not in the Web Configurator.

13.4.1 PPP Interface Summary

This screen lists every PPPoE/PPTP interface. To access this screen, click
Configuration > Network > Interface > PPP.
ZyWALL USG 1000 User's Guide
Chapter 13 Interfaces
293