ZyXEL Communications ZyWALL USG 1000 User Manual page 822

Unified security gateway

Hide thumbs Also See for ZyWALL USG 1000:

Table of Contents

Chapter 50 System

settings, including from which zones SNMP can be used to access the ZyWALL. You

can also specify from which IP addresses the access can come.

Figure 549 Configuration > System > SNMP

The following table describes the labels in this screen.

Table 239 Configuration > System > SNMP

Select the check box to allow or disallow the computer with the IP

address that matches the IP address(es) in the Service Control table to

access the ZyWALL using this service.

You may change the server port number for a service if needed, however

you must use the same port number in order to use that service for

remote management.

Enter the Get Community, which is the password for the incoming Get

and GetNext requests from the management station. The default is

public and allows all requests.

Enter the Set community, which is the password for incoming Set

requests from the management station. The default is private and allows

all requests.

Type the trap community, which is the password sent with each trap to

the SNMP manager. The default is public and allows all requests.

Type the IP address of the station to send your SNMP traps to.

This specifies from which computers you can access which ZyWALL

ZyWALL USG 1000 User's Guide

Troubleshooting