Hitachi DZ-MV780A Instruction Manual page 90

USING THE ELECTRONIC IMAGE STABILIZER (EIS)
When you nse zoom (see page 56) to record a magnified snbject image, it will correct f\lzziness in tile
recorded image.
Press the MENU
button, choose "EIS" on
the "Camera Functions
Setup" inellU screen,
and then press tile I_/||
button.
I [#_ENTER ]_]RETURN ?;RAM I
h Choose tile "Oil" o1""Off", and then press tile
I_III button.
3 Press the MENU button to end tile setting.
OChecking EIS On or Off
You can check EIS On oi"Off by tile on screen
information display.
E IS -- .m_oM,.
OR_I S_0OA_
9,'30'200S
After recording with EIS set to "Off", it is
recommended that you return tile setting to
"On" and then turn tile DVD video camera/
recorder off, unless you normally record with
"Off" setting.
Note;
• The EIS setting wilt be stored in memory even when
the DVD video camera/recorder is turned off.
• It is recommended that you specify "EIS Off" when
using the DVD video camera/recorder on a desk or
tripod
• When "EIS On" is specified, there will be a slight
difference between the actual movement and the
movement on screen.
• Gross camera shake may not be entirely corrected
even if "EIS On" is specified: Firmly hold the DVD
video camera/recorder with both hands.
• EIS may not operate correctly when the tele or wide-
conversion lens is used
• EIS cannot be used when recording photos on DZ-
GX20A or DZ-MV780A.
RECORDING SUBJECT USING LARGE MAGNIFICATION (DIGITAL ZOOM)
See page 56 for setting on digital zoom.
REDUCING WIND NOISE DURING RECORDING (MIC.FILTER)
When recording sound from tile microphone built into this DVD video camera/recorder, you can
reduce wind noise in recording.
If "MIC.Filter: ON" is specified, tile low fl'equency components in tile sound picked up by
microphone will be cut off during recording: This makes it easier to hear tile target voice or sound
during playback.
A
I Press the MENU
button, choose
"MlC.Filter" on tile
"Camera Functions
Setup" nlenu screen,
and then press
tile I_III
button.
/. Choose the desired option, and then press the
I,,/II buttoT1.
3
Press the MENU button [ T
to end tile setting. ,V,., 0_g_{00
_Em30 Mm
OR_ 8100AM
Note:
• You can also use the on-
screen display to confirm Microphone filter icon
that the MIC Fitter has been
set
• The MIC Filter setting will be stored in memory even
when the DVD video camera/recorder is turned off
• The MIC Fitter function will work only during movie
recording
• The microphone filter function works only with the
built-in microphone: It will not function when using an
external microphone (p 75).
9O