Battery Charging; Tabletop To Wall Mount Installation - VTech DS6520-22 User Manual

Battery charging

Once you have installed the battery, the screen indicates the battery status (see
the table below). For best performance, keep the handset in the telephone base
or charger when not in use. The battery is fully charged after 2 hours of
continuous charging.
Battery indicators
The screen is blank, or
shows Put in charger and
flashes.
The screen shows
Low battery and
flashes.
The screen shows
HANDSET X.
• If you place the handset in the telephone base or charger without plugging in the
battery, the screen displays NO BATTERY.

Tabletop to wall mount installation

The telephone comes ready for tabletop use. Follow the steps below to mount your
telephone on a wall.
. If you have already installed the
telephone for tabletop use, unplug
the telephone line cord from the
telephone wall jack, and unplug
the telephone base power adapter
from the wall outlet. Remove the
telephone line cord and the power
adapter cord from the grooves.
3. Position the lower portion grooves
on the telephone base to the lower
portion tabs (marked B) on the wall
mount bracket. Make sure the upper
portion grooves of the telephone
base are above the upper portion
tabs (marked A) on the wall mount
bracket. Push the telephone base
down until it clicks securely in place.
Battery status
The battery has no charge
or very little charge. The
handset cannot be used.
The battery has enough
charge to be used for a
short time.
The battery is charged.
2.
4.
3
Charge without interruption
(at least 30 minutes).
Charge without interruption
(at least 30 minutes).
To keep the battery
charged, place it in the
telephone base or charger
when not in use.
Route the telephone line cord
through the rectangular hole on the
wall mount bracket and plug it into
the telephone wall jack. Route the
power cord out of the telephone base
and plug it into an electrical outlet not
controlled by a wall switch.
Align the holes on the bracket with
the standard wall plate and slide the
bracket down until it locks securely.
Bundle the telephone line cord
and power adapter cord neatly
with twist ties.
Action