Hitachi DZ-HS903A Instruction Manual page 156

Message
Write protected.
Check HDD/DVD.
*1
• This message may also appear if the disc is dirty. If this message appears when a recorded disc is
recognized immediately after it is inserted, do not repair the disc; remove it and then use a soft cloth
to clean off the dirt before using it.
• This message may also appear when condensation occurs. In this case, do not repair the disc; turn
the camcorder off, wait until it dries out, and then turn it on again.
• If the repair message appears when you turn the camcorder on from off with a disc loaded after
recording on it, select repair.
• If the repair message appears when recording and playback are normally possible with another disc
– and no condensation has occurred, and the disc is not dirty – select repair.
*2
• This message may also appear if the disc is dirty. In this case, do not format the disc. Remove it and
then use a soft cloth to clean off the dirt before using it.
• This message may also appear when condensation occurs. In this case, do not format the disc; turn
the camcorder off, wait until it dries out, and then turn it on again.
• Formatting will delete all data on the disc.
*3
• This message may also appear when the disc is dirty. Remove the disc and then use a soft cloth to
clean off the dirt before using it.
• This message may also appear when condensation occurs. Wait until the camcorder dries out, and
then turn it on again.
*4
• This message will appear when a single-sided disc is inserted the wrong way (upside down).
Reinsert the disc correctly. (Insert the disc with the label printed surface facing toward the outside.)
*5
• Do not insert a DVD-RW (VF mode)/DVD-R disc that has not been finalized into any DVD
recorder. The disc may become unusable.
156
Cause & Troubleshooting
The HDD or disc is write-protected. Use the Disc
Navigation menu to release the protection.
Reference
page
113