Complete Installation; Range Hood Use; Range Hood Controls; Range Hood Care - KitchenAid 36" (91.4 CM) ISLAND CANOPY RANGE HOOD Installation Instructions And Use & Care Manual

Complete Installation

1. For non-vented (recirculating) installations only, install
charcoal filters over grille on blower housing. See the "Range
Hood Care" section.
2. Install metal filters. See the "Range Hood Care" section.
3. Check the operation of the range hood blower and light. See
the "Range Hood Use" section.
If range hood does not operate, check to see whether a
circuit breaker has tripped or a household fuse has blown.
NOTE: To get the most efficient use from your new range hood,
read the "Range Hood Use" section.

RANGE HOOD USE

The range hood is designed to remove smoke, cooking vapors
and odors from the cooktop area. For best results, start the hood
before cooking and allow it to operate several minutes after the
cooking is complete to clear all smoke and odors from the
kitchen.
The range hood controls are located on the front side of the
canopy.
A
B
C
D
E
A. Louver holes (non-vented
[recirculating] installations only)
B. Duct covers
C. Lamp housings

Range Hood Controls

A B
A. Light On/Off button
B. Blower On/Off button
C. Blower speed minimum button
D. Blower speed medium button
E. Blower speed maximum button
NOTE: Control buttons will light up when range hood is On.
10
G
D. Canopy
E. Grease filter
F. Grease filter handle
G. Control panel
C
D E
Operating the light
The Light On/Off button (A) controls both lights. Press once for
On and again for Off.
Operating the blower
The Blower On/Off button (B) turns the blower On or Off. The
Blower Speed buttons (C, D and E) set the desired speed and
control the sound level for quiet operation. The speed can be
changed anytime during fan operation by pressing the desired
blower speed button.
1. To turn the blower On, press the Blower On/Off button (B) and
the desired speed button (C, D or E).
2. To turn the blower Off, press the Blower On/Off button (B).
Any of the 3 blower speed buttons can be in the On position at
the same time. The blower will operate at the highest speed
button that is pushed in. For lower blower speeds, the higher
speed buttons must not be pushed in.

RANGE HOOD CARE

IMPORTANT: Clean the hood and grease filters frequently
according to the following instructions. Replace grease filters
before operating hood.
Exterior Surfaces:
To avoid damage to the exterior surface, do not use steel wool or
soap-filled scouring pads.
Always wipe dry to avoid water marks.
Cleaning Method:
Liquid detergent soap and water, or all-purpose cleanser
Wipe with damp soft cloth or nonabrasive sponge, then rinse
F
with clean water and wipe dry.
Metal Grease Filter:
1. Remove the filter by pulling the spring release handle and
then pulling down the filter.
2. Wash metal filters as needed in dishwasher or hot detergent
solution.
3. Reinstall the filter by making sure the spring release handle is
toward the side. Insert aluminum filter into upper track.
4. Push in spring release handle.
5. Push up on metal filter and release handle to latch into place.

Cleaning

A
A. Spring release handle