Li-Ion Battery Handling Precautions; Display Readings - Kidde KN-COPP-3 Owner's Manual

Display Readings

DC Powered in Battery Backup Operation
LED
If at any time you test the alarm and it does not perform as described, have it replaced immediately.

Li-Ion Battery Handling Precautions

Handling
• Do not use the battery for a purpose other than for the alarm it is
specified.
• Do not recharge the battery using any charging circuit other than the one
provided in the alarm. A recharging operation under non-conforming
recharging conditions can cause electrolyte leakage, overheating,
smoke emission, bulging/bursting and/or ignition.
• Do not discard the battery into fire or heat it under any circumstances.
Otherwise, it may cause the battery to explode. Do not connect the
battery to an electrical outlet.
32
Display Alarm Sound Unit Status
Shows
"0" or CO 1 "chirp"
concentration
every 15
and "Lb"
seconds
displayed
once every 60
seconds,
flashing dot
every second.
Flashing dot 1 "chirp"
once every 60
every 60
seconds.
seconds
None. None.
Unit Condition
Battery conserve Battery is partially
mode, sensing for discharged, after
CO. 5 minutes of
operation on
battery backup.
Unit in trouble Operation on
alarm. Mode will battery backup
continue for and battery is
approximately 7 fully discharged.
hours. WILL NOT
DETECT CO.
Unit is not Battery
operational. WILL disconnected or
NOT DETECT CO. missing.
Recommended
Action
Confirm battery
connection is fully
seated & oriented
properly. Connect
to AC power to
fully charge
battery. Contact
Kidde customer
service if condition
continues.
Confirm battery
connection is fully
seated & oriented
properly. Connect
to AC power to
fully charge
battery. Contact
Kidde customer
service if condition
continues.
Confirm battery
connection is fully
seated & oriented
properly. Connect
to AC power to
fully charge
battery. Contact
Kidde customer
service if condition
continues.