Installation Instructions; Battery Installation And Replacement - Kidde KN-COB-LP2 User Manual

4. Installation Instructions

Battery Installation and Replacement

To install or replace the batteries in this Kidde CO alarm, please perform
the following steps.
1. Slide open the bottom cover to expose the battery compartment.
2. If replacing batteries, remove the old batteries and properly dispose
of them as recommended by the battery manufacturer.
3. Install the new batteries. Note the polarity
illustration in the battery compartment.
4. Close the bottom cover. Note: The bottom
cover will not close if all AA batteries are not
installed.
When replacing the batteries, use one of the
following approved Alkaline brands:
• Duracell
• Energizer E91
• Gold Peak 15A
• Golden Power GLR6A
These batteries can be purchased where you bought the alarm or at a
local hardware store. Use of a different battery may have a detrimental
effect on the alarm operation.
NOTE: Do not use LIthium batteries in this unit.
IMPORTANT: Constant exposures to high or low humidity may reduce
battery life. A good safety measure is to replace the battery at least
once a year, or at the same time as you change your clocks for daylight
saving time.
After installing or changing the batteries, reinstall your alarm. Test
your alarm by using the Test/Reset button and check that the green LED
flashes once approximately every 60 seconds.
Low Battery HUSH® CONTROL
When the batteries need to be replaced, the unit will produce a low
battery warning. The Low Battery HUSH® feature allows you to press
the button on the alarm and disable the "chirp" for a random period of
up to 12 hours. This gives you a chance to replace the battery at a more
convenient time by disconnecting the alarm from power. During this Low
Battery HUSH® period, your alarm is monitoring for CO.
MN1500 or MX1500
Battery Polarity
for the two AA batteries