Kidde KN-COPP-3 Owner's Manual page 33

Display Readings
AC Powered in Normal Stand-by Operation
LED Display
Shows
Flashes "0"
alternating
alternately
with "Lb" and
a flashing dot.
"0"
alternating
with "Lb" and
a flashing dot.
If at any time you test the alarm and it does not perform as described, have it replaced immediately.
DC Powered in Battery Backup Operation
LED Display
Shows
"0".
"0" or CO
concentration
displayed
once every 60
seconds;
flashing dot.
"0" or CO
concentration
alternating
with "Lb".
Alarm Sound Unit Status
None. Charging battery
pack. Initial
power-up or power
was reset.
1 beep every Battery
15 seconds. disconnected or
not charging.
Alarm Sound Unit Status
None. Operation on
battery backup,
sensing for CO.
None. Battery conserve
mode, sensing for
CO.
None. Battery conserve
mode, sensing for
CO.
Unit Condition Recommended
Action
Battery Keep unit on AC
discharged less to fully charge
than 10 hours on battery. "Lb" will
AC. Battery is in disappear once
charge state. battery is charged
depending on
initial charge.
Battery Connect battery
discharged or pack. "Lb" will
disconnected disappear once
longer than 10 battery is charged
hours. depending on
initial charge.
Unit Condition Recommended
Action
Battery is fully Connect to AC
charged. First 5 power.
minutes on
battery backup
Battery is fully Normal battery-
charged and after only operation.
5 minutes of To recharge
operation on battery connect
battery backup. to AC power.
Battery is partially Connect to AC
power to fully
discharged, first 5
recharge battery.
minutes of
operation on
battery backup.
31