Quick Set-Up - Kidde KN-COPP-3 Owner's Manual

Quick Set-Up

We urge you to read this entire manual in the sequence it
is presented. But, if you only read one part of this guide
initially, read this page! Listed below are seven easy steps
for setting up your unit. Please read the entire guide for
complete information.
Step 1
Determine the best location for your CO alarm(s). Refer to
Page 7 for complete information.
Step 2
Your CO alarm is equipped to be mounted as a corded unit,
a direct plug unit, or a tabletop unit. In the "as shipped"
configuration, the unit can be plugged directly into a wall
socket (if your outlets are mounted horizontally, please
refer to page 10). If the transformer / adaptor is taken out
of the unit, the alarm can be mounted on the wall at eye
level, while the transformer is plugged into a wall socket.
The unit can also be set on a table if the support at the
bottom of the unit is pulled out (see "rear view" illustration
on page 4). Refer to page 11 for further information on
installing your alarm.
Step 3
A rechargeable battery pack is provided for backup in the
event of a power outage. To install the battery pack, open
the back door and align the connector with the slot in the
battery. Insure the orientation of the two alignment ribs
align with the slot in the battery. Press the connector in
until it is fully seated. Depending on the charge state of the
battery pack (the battery packs can have different amounts
of energy stored in them due to storage time), you may
hear the alarm sound briefly to indicate the alarm is
receiving power. Place battery pack into battery
compartment and replace back door.
Note: Battery backup will be limited until the battery has
fully charged. It may take up to 24 hours for the battery
back up to fully charge.
2