System Reset - Jensen VM9216BT Operating Instructions Manual

System Reset

To correct a system halt or other illegal operation,
use the tip of a pen to press the reset button
located on the front bottom-right corner of the unit.
After a system reset, the unit restores all factory default settings.
NOTE: If the unit is reset while a DVD is playing, the DVD resumes play once the
reset is complete.
Image/Display Settings
Video Output Modes
Table 5 shows the video output mode for each playing source.
Playing Source
AM/FM TUNER
DVD
AUX IN
*CVBS – Composite Video Baseband Signal
Picture Adjustment
To adjust monitor display settings, perform the following steps:
Press the PIC button on the monitor to display the picture adjustment menu.
1.
The "BRIGHT" bar is highlighted in yellow.
2. Turn the rotary encoder to adjust the brightness setting level.
3. Press the PIC button again. The "CONTRAST" bar is highlighted in yellow.
4. Turn the rotary encoder to adjust the contrast setting level.
5. Press the PIC button again to exit the picture adjustment menu.
Parking Brake Inhibit
When the pink "Parking" wire is connected to the vehicle Parking Brake circuit, the
front TFT monitor will display video when the Parking Brake is engaged. (When
the pink wire is grounded via the Parking Brake circuit, video will be displayed.)
24
Table 5: Video Output Modes
Video Output Modes
YCbCr Mode
YCbCr Mode
CVBS Mode
VM9216BT
[RESET] Button