Follett HCC1400A Operation And Service Manual page 6

Dimensions and clearances
Entire front of icemaker must be clear of obstructions/connections to allow removal.
1" (26mm) clearance above icemaker for service.
1" (26mm) minimum clearance on sides.
The intake and exhaust air grilles must provide at least 170 sq in (968 sq cm) of open area.
Air-cooled model HCC1400A icemakers – 18" (458mm) minimum clearance between discharge and air
intake-grilles.
Front View
Air intake
Side View
21.28" (541mm)
23.50"
(597mm)
CORPOR A TIO N Easton Pennsyl v ania
MODEL SERIAL NO P ART N O
SINGLE
FULL LOAD AMP S VOLTS HZ PHASE
208264 MOT OR COMPRESSOR THERMAL LY PR OTECTE D
Stock Module Identification Plat e
Module No. REFRIGERANT CHARGE OZ
Product
DESIGN PRESSURE HIGH SIDE LOW SID E PSIG
Service No.
MIN. BRANCH CIRCUIT AM P ACI T Y AMPS U U MADE IN
L L NSF THE USA
MAX. BRANCH CIRCUIT FUSE SIZ E AMPS R C R
21.05" (535mm)
23.8" (580mm)
Ice transport hose connection
NEMA 6-20
right angle
Air exhaust
both sides
G
1/4" FPT
condenser drain
1/4" FPT
condenser inlet
15.56"
(395mm)
6.97"
(177mm)
2.53"
(64mm)
2.72"
(69mm)
3/8" OD push-in water inlet
3/4" MPT drain
6
Back View
Air exhaust
29.7" (755mm)
2.43" (62mm)