Specifications - Follett HCD1000R Operation And Service Manual

Specifications

Electrical
Separate circuit and equipment ground required.
Evaporator unit
Standard electrical – 115/60/1
Maximum fuse – 15 amps
Amperage – 6 amps
Condenser unit
Standard electrical – 220V, 60Hz, 1 phase
Maximum fuse – 30 amps
Amperage – 17.6 amps
Evaporator plumbing
3/8" OD push-in water inlet
3/4" MPT
Notes: 3/4" vented drain line must slope a minimum of 1/4" per foot (6mm per 30.4cm run).
Drain to be hard piped and insulated.
Water shut-off recommended within 10 feet (3m).
Follett recommends installation of Follett water filter system (part# 00130286) in icemaker
inlet water line.
Ambient
Evaporator unit
Air temperature
Water temperature
Water pressure
Condenser unit
Air temperature
Refrigeration
3/8" liquid line
5/8" suction line
Note: Rack system installations require a reserve capacity of 7,500 BTU/hr at
2˚F ( – 17˚C) evaporator temperature.
Evaporator pressure regulator (not supplied) is required.
Weight
Evaporator unit
160 lbs (73kg)
Condenser unit
265 lbs (120kg)
100˚F/38˚C max.
90˚F/32˚C max.
70 psi max. (483 kPa)
120˚F/49˚C max.
50˚F/10˚C min.
45˚F/7˚C min.
10 psi min. (69 kPa)
– 20˚F/-29˚C min.
Ice production
Air-cooled icemaker capacity/24 hrs.
Ambient Air Temperature F/C
60
F
16
C
50 1101
10 499
60 1045
474
16
990
70
21 449
80 935
27 424
879
90
399
32
5
70 80 90 100
21 27 32 38
1036 969 901 811 lbs
470 440 409 368 kg
980 913 845 755 lbs
445 414 383 342 kg
925 858 790 700 lbs
420 389 358 318 kg
870 803 735 645 lbs
395 364 333 293 kg
814 747 679 589 lbs
369 339 308 267 kg