Evaporator Reassembly - Follett HCD1000R Operation And Service Manual

Evaporator reassembly

1. Remove and inspect O ring seal. Discard if
damaged in any way.
2. Clean O ring groove. Lubricate O ring with petrol-
gel and reinstall.
3. Press new mating ring into main housing as shown.
4. Lube the shaft with liquid soap in the area shown and
slip on seal and spring.
Note: Do not touch the sealing surfaces. Use
cardboard disk to install.
5. Reinstall main housing as shown.
Fig. 18
Fig. 19
Lube
with soap
Do not
touch
Fig. 20
21
Cardboard
disc