Table of Contents
Advertisement
531450-1_A - 383c_Eng.qxd
11/18/2005
NMEA Output
(Advanced)
NMEA Output turns the NMEA* output on or off. This menu choice is available only when in
Advanced User Mode (see Setup Menu Tab: User Mode.) NMEA Output should be turned On
if you connect the NMEA Output wires of the GPS Receiver cable to another NMEA-
compatible device, such as an autopilot.
*NMEA 0183 is a National Marine Electronics Association standard for data communication.
The following NMEA sentences are output when NMEA Output is turned On:
DPT- Depth
MTW - Water Temperature
GLL - Lat/Lon Position
GGA - GPS Fix Data
RMC - Recommended Minimum Specific GNSS Data
VTG - Course Over Ground and Ground Speed
ZDA - Time and Date
When navigating, the following NMEA sentences are also output when NMEA Output
is turned On:
APB - Autopilot Sentence B
BWR - Bearing and Distance to Waypoint
RMB - Recommended Minimum Navigation Info
To turn NMEA Output on or off:
1. Make sure you are in Advanced User Mode, then highlight NMEA Output on the
Setup menu.
2. Use the LEFT or RIGHT 4-WAY Cursor Control keys to change the NMEA Output to On
or Off (Off, On, Default = Off).
Sonar
Sonar deactivates Sonar and removes the Sonar Views from
the view rotation.
To turn Sonar on or off:
1. Highlight Sonar on the Setup menu.
2. Use the LEFT or RIGHT 4-WAY Cursor Control keys to change the Sonar to On or Off
(Off, On, Default = On).
2:38 PM
Page 92
85
Views Menu Tab
From any view, press the MENU key twice to access the
tabbed Main Menu System, then press the RIGHT 4-WAY
Cursor Control key until the Views tab is selected. This
menu tab allows you to set the available views to either
hidden or visible in the view rotation. The view will be
removed from the view rotation if it is set to Hidden and
will be displayed in the view rotation if it is set to Visible.
The following views are available:
• Bird's Eye View
• Chart View
• Combo View
• Sonar View
• Sonar Zoom View
• 200/83 kHz Split Sonar View
Views Menu
• Big Digits View
• Circular Flasher View
• Self Test
• Accessory Test
• GPS Diagnostic View.
To Change the View Status of Any View:
1. Highlight the View main menu tab.
2. Use the UP or DOWN 4-WAY Cursor Control keys to select a View.
3. Use the LEFT or RIGHT 4-WAY Cursor Control keys to change the status of the
view from Hidden to Visible.
86
Advertisement
Table of Contents
