Troubleshooting Guide; Year Limited Warranty - Heath Zenith Motion Sensor Quartz Security Light 2LBN2 Operating Instructions And Parts Manual

SYMPTOM POSSIBLE CAUSE
Light will not come on. 1. Light switch is turned off.
2. Flood lamp is loose or burned out.
3. Fuse is blown or circuit breaker is turned off.
4. Daylight turn-off is in effect.
5. Incorrect circuit wiring, if this is a new installation.
6. Sensor does not detect objects in desired area.
Light comes on in day- 1. Light control may be installed in a relatively dark
light.
2. Light control is in TEST.
Light comes on for no 1. Light control may be sensing small animals or auto-
apparent reason.
2. Range is set too high.
3. D
Light turns off too late in Light control may be installed in a relatively dark loca-
Dusk-to-Dawn setting. tion.
Light stays on continu- 1. A flood lamp is positioned too close to the light control
ously.
2. The light control may be picking up a heat source
3. Light control is in manual mode.
Light flashes on and 1. Heat or light from the flood lamp may be turning the
off.
2. Heat being reflected from other objects may be turn-
3. Light control is in the TEST mode and warming up.
Light flashes once, then Light control is detecting its own light.
stays off in manual
mode.

1 YEAR LIMITED WARRANTY:

Should this product fail to perform satisfactorily due to a defect or poor workmanship within one year of date of
purchase, return it to the place of purchase and it will be replaced, free of charge. Incidental or consequential
damages are excluded from this warranty. Light bulbs are not covered.
Manufactured for Grainger International, Inc.
598-1114-04
Lake Forest, IL 60045

TROUBLESHOOTING GUIDE

location.
mobile traffic.
B timer is on.
®
ual rite
or pointed at nearby objects that cause heat to trigger
the light control.
like an air vent, dryer vent, or brightly painted, heat-
reflective surface.
light control on and off.
ing the light control on and off.
SOLUTION
1. Turn light switch on.
2. Check flood lamp and replace if burned out.
3. Replace fuse or turn circuit breaker on.
4. Recheck after dark.
5. Verify wiring is correct.
6. Re-aim sensor to cover desired area. Increase sen-
sitivity.
1. Relocate light fixture to another junction box with
increased amount of daylight.
2. Set control switch to 1, 5, or 10 minutes.
1. Re-aim light control.
2. Reduce range. Turn Range Boost off.
3. Turn D B
ual
Relocate light control, or use 3 hr. or 6 hr. setting.
1. Reposition the flood lamp away from the light control
or nearby objects.
2. Reduce range. Re-aim sensor. Turn Range Boost
off.
3. Switch light control to AUTO.
1. Reposition the flood lamp away from the light con-
trol.
2. Reposition light control.
3. Flashing is normal under these conditions.
Reposition flood lamp to keep area below the light
control relatively dark.
-5-
Timer off.
®
rite