Heath Zenith Wireless Chime 598-1172-04 Owner's Manual page 6

3. To change the code, either:
• Add a jumper to the same location on both the push button and the chime or...
• Remove a jumper from the same location on both the push button and the chime or...
• Move a jumper on the push button from one location to another. Move the corresponding
jumper on the chime to match the new location in the push button.
Example: Move jumper at location "5" to location "4" on both the push button and the
chime.
Note: Code positions 1 through 7 must be exactly the same for both the push button and
chime for this system to function.
Note: Unit will come factory set with jumpers in locations 5, 6, and 7 on the push button and
on the chime (see Figure 10).
The range of the wireless chime can vary with location, temperature, and battery condition.
VOLUME
Front of Chime Base
* Code Settings 1-7
Must Match Both Push
Button and Chime
Figure 10
Note: Some models might require the use of
tweezers to remove and replace the jumpers.
-6-
Inside Push Button
598-1172-04