Table of Contents
Advertisement
R
B. Leg Kit and Ash Removal Installation
(ARS) for Step Top Uni-Body
NOTE: The Ash Removal System, must be
installed first before installing the legs.
Installing Leg Kit
1. Remove leg mounting brackets packaged inside firebox.
2. Attach the 2 bottom screws of the mounting brackets to
the bottom of the stove with 1/4"-20 Phillips head screws.
These screws are located in the component pack .
Leave the bottom 2 screws loose so you can slide the ash
pan assembly bottom slots over the screw heads. This al-
lows the weight of the ash pan to rest on the screws while
you are attaching the top 2 screws. Once the ash pan is
attached, tighten all screws. Figure 23.2.
. Loosely assemble bolts into the corner of the mounting
brackets for leg attachment. Figure 23.1.
4. Slide legs onto mounting brackets and tighten. Make sure
the legs are up against the bracket. There are leveling
bolts in 2 legs. These leveling legs should be in opposite
corners. Figure 23.1.
5. Carefully stand stove up and place in desired location.
Do NOT tilt up on the cast iron legs, it could damage the
legs.
6. Use leveling bolts on legs to stabilize and level stove.
Finishing the ARS Installation
1. Follow steps 1 through on page 22. See also Figure
22.2.
Figure 23.1
September 1, 2008
Leg Mounting Brackets are
packaged inside firebox.
Leveling Legs at
opposite corners
Lay stove flat on its
back on protective
padding or pallet
Figure 23.2
Do NOT tilt the unit on the cast iron legs.
•
Tilting could lead to property damage.
•
Lift the unit upright and place it into position on the
floor protector.
7037-135E
4300 Wood Stove Series (ACC)
Insert 2 bottom
screws loosely
Leg Brackets
CAUTION
Ash Drawer
Page 2
Advertisement
Table of Contents
