Quick Start Quide - Quadra-Fire MT VERNON Pellet Insert Advanced Energy (AE) MTVERNINSAE-CSB Owner's Manual

R
H. Quick Start Guide
Any button pressed will turn on the backlight. Wall control will automati-
NOTICE:
cally revert back to the starting screen if there is no activity for 15 seconds; except
for the "CONFIRM FUEL CHANGE" screen.
CHOOSING FUEL TYPE
R A
et at:
MENU
1. At the starting screen, press "MENU"
button once or twice until "MENU"
screen appears.
M N
et omfort Level
Auto Manual Off
uel T pe
ser ettings
2. Highlight "FUEL TYPE" using the "UP/
DOWN" buttons to the right side of the
display. Press "SELECT".
L L TION
oftwood ellet
unflower eeds
Wheat
ardwood ellet
3. Scroll down and highlight "HARD-
WOOD PELLET" or your fuel type.
4. Now press "SELECT" to choose new
fuel
ON IRM L AN
lease empt hopper
of old fuel t pe and
ensure firebox is clean
lease refer to
section in manual
DONE
5. Press "DONE" to
change.
6. Press "DONE" twice or wait 15 sec-
onds for starting screen to reap-
pear.
7. Fill the hopper with fuel, and if the
hopper was completely empty, or has
run out of fuel, throw approximately
1/2 cup of pellets into the firepot.
8. Be sure the hopper lid and glass
door are both closed.
September 1, 2008
: M
Wall Control for Reference
TURNING ON APPLIANCE
1. At the starting screen, press "MENU".
2. Highlight "AUTO/MANUAL/OFF".
Press "SELECT".
3. Highlight "MANUAL". Press "SELECT
4. Press "DONE" twice or wait 15 seconds
confirm fuel
for starting screen to reappear.
Buttons
U
R A : M
et at:
MENU E U U
R A : M
et at:
MENU
M N
et omfort Level
Auto Manual Off
uel T pe
ser ettings
A TO MAN AL TTIN
Automatic
Manual
Manual
Off
7036-135E
Mt. Vernon Pellet Insert (AE)
CHOOSING TEMP UNIT:
°F or °C
R A
MENU
1. At the starting screen, press "MENU"
button once or twice until "MENU"
screen appears.
M N
et omfort Level
Auto Manual Off
uel T pe
ser ettings
2. Highlight "USER SETTINGS" using the
"UP/DOWN" buttons to the right side of
the display. Press "SELECT".
R TTIN
Temp nits
lame eight Adjust
Temp ifferential
2. Highlight "TEMP UNITS F/C" using the
"UP/DOWN" buttons to the right side of
the display. Press "SELECT".
".
3. Press the "UP" or "DOWN" button
to set desired temperature unit and
press "SELECT"..
4. Press "DONE". Press "DONE" again,
or wait 15 seconds for starting screen
to reappear.
: M
et at:
Page 27