General Operation Information; Before Your First Fire; Starting Your First Fire - Quadra-Fire MT VERNON Pellet Insert Advanced Energy (AE) MTVERNINSAE-CSB Owner's Manual

Mt. Vernon Pellet Insert (AE)
B. General Operating Information
See Wall Control Thermostat Manual
for detailed operating instructions.
1. Wall Control Thermostat - Automatic Setting
The appliance is like most modern furnaces; when the
wall control thermostat calls for heat, your appliance will
automatically light and deliver heat. When the room is up to
temperature and the wall control is satisfied the appliance
will shut down.
In the automatic setting the heat output level is controlled
by the wall control. Select "Automatic" on the AUTO/
MANUAL screen. Figure 24.1.
Automatic
Manual
Off
Figure 24.1
2. Wall Control Thermostat - Manual Setting
When you select "Manual" on the AUTO/MANUAL screen
the appliance will still automatically turn on and off
according to the temperature setting. However, you will
be able to manually control the heat output levels. Adjust
the heat output levels by using the HEAT OUTPUT LEVEL
screen.
Figure 24.2
3. Auto-Clean Firepot System
Your appliance is equipped with an automatic firepot
cleaning system that will change the frequency of cleaning
based on the fuel being burned.
The auto-clean system will clean itself immediately on
initial plug in. If there is a power outage, as soon as power
is restored it will automatically clean itself.
Page 24
Medium
C. Before Your First Fire
1. First, make sure your appliance has been properly installed
and that all safety requirements have been met. Pay
particular attention to the fire protection, venting and wall
control thermostat installation instructions.
2. Double check that the ash pan and firebox are empty and
then close the front door.
Tip of thermocouple must be in contact with the inside
end of the thermocouple cover
Missed ignitions can occur.
D. Starting Your First Fire
1. Fuel Selection
To start your first fire, you must select the appropriate fuel on
the FUEL SELECTION screen on the wall control to match the
fuel you have chosen to burn.
If the proper fuel is not selected your appliance will not operate
properly. For example, if you have selected wood pellets and
you are burning corn, the appliance may not light or may go out
or overfeed. Even if the correct fuel is already highlighted, press
"select" anyway to ensure proper initialization of the system.
Figure 24.3.
2. Comfort Level Selection
Once your fuel is selected, select the temperature at the desired
setting on the SET COMFORT LEVEL screen. Figure 24.4.
3. Automatic or Manual Setting
The automatic setting will control the heat output based on
the comfort level selection. The manual setting allows you to
manually control the heat output settings. See Ignition Cycles
on page 25.
NOTE: See the Wall Control Thermostat manual for detailed
instructions.
FUEL SELECTION
Corn
Utility Pellet
Softwood Pellet
Sunflower Seeds
Wheat
Hardwood Pellet
DONE
Figure 24.3
Figure 24.4
7036-135E
CAUTION
SELECT
September 1, 2008
R