Install The Refractory (Exclaim-42 Only) - Heat & Glo LifeStyle Wood Burning Fireplace EXCLAIM-36 Owner's Manual

F. Install the Refractory (EXCLAIM-42 only)
We recommend two installers for hearth stone and refrac-
tory installation!
• Set back refractory into place, making sure refractory is
centered and notches are to the bottom of fi rebox.
• Place grate brackets in outer two notches of refractory.
See Figure 7.9.
• Secure back refractory in place with a screw and bracket
supplied in hardware package. See Figure 7.10.
GRATE BRACKETS
Figure 7.9 Back Refractory with Grate Brackets in Place
Figure 7.10 Attaching Back Refractory
REFRACTORY
BRACKET
Heat & Glo • EXCLAIM-36, EXCLAIM-42 • 4013-251 Rev C • 11/08
Note:
To ensure proper installation, gas knockouts in the side
refractory should be positioned towards back of fi replace. See
Figure 7.11.
GAS
KNOCKOUT
Figure 7.11 Gas Knockout
• Tilt top of side refractory towards center of fi rebox when
placing it into fi replace. Push side refractory towards
back corner of fi replace until it fi ts tightly against back
refractory.
• Secure side refractory in place with a screw and bracket
provided in the hardware package.
• Repeat these two steps for installation of the other side
refractory.
• When placing hearth stone into fi replace, slide it back
until it fi ts tightly against back refractory (underneath
grate brackets). See Figure 7.12.
GRATE
BRACKET
Figure 7.12 Sliding Bottom Refractory Towards
Back of Fireplace
• Place grate into grate brackets. See Figure 7.13.
• Replace smoke shield.
GRATE
BRACKET
Figure 7.13 Grate Secured in Grate Bracket
• Replace left and right screens.
23