Lcd Module - ATEN CL5808 User Manual

LCD Module

No. Component
1 LCD Display
2 Port Navigation
Switches
3 LCD OSD
Controls
4 LCD Power
Button
5 Firmware
Upgrade
Section
1
2
3
4
5
After sliding the LCD module out, flip up the cover to access
the LCD monitor.
These buttons can be used to access a port when the
Keyboard Module isn't extended. Press the UP or DOWN
button to cycle forward or backward through the ports.
The left (DOWN) button shifts the KVM focus down the
→
chain (Port 2
last port.
The right (UP) button shifts the KVM focus up the chain.
After the last port, it cycles back to Port 1.
Buttons to control the position and picture settings of the
LCD display are located here. See LCD OSD Configuration,
page 26, for details.
Press this button to turn the LCD monitor on and off. When
the LCD monitor is off, this button illuminates; when the LCD
monitor is on, this button does not illuminate. (This function
only affects the monitor, not the KVM switch itself.)
Firmware Upgrade Port: The Firmware Upgrade Cable
that transfers the firmware upgrade data from the adminis-
trator's computer to the CL5808/CL5816 plugs into this
RJ-11 connector.
Firmware Upgrade Switch: During normal operation this
switch should be in the NORMAL position. (See The
Firmware Upgrade Utility, page 57 for firmware upgrading
details.)
Description
Port 1, etc.). After Port 1, it cycles to the
1. Introduction
9