Installation - Solar Storage Tank - Rheem Solar Loline Water Heater Owner's Manual And Installation Instructions

INSTALLATION – SOLAR STORAGE TANK
THIS WATER HEATER IS NOT SUITABLE FOR POOL HEATING.
The system is suitable for installation with Rheem NPT 200 or HBT 200 solar collectors. The system is not
suitable for installation above 400 metres altitude.
IMPORTANT NOTES

Working on roofs is and should always be considered a hazardous activity, particularly early in the
morning, late in the evening, when the roof is wet or during and after periods of rain.

All work must be carried out in accordance with Local, State and Federal Occupational Safety, Health
and Welfare Regulations. In particular, the requirements for safety whilst manual lifting, working at
heights and on roofs.

Installers must be competently trained in:
Height Hazard Assessment

Working at Height Procedures

Assessment / Use / Wearing of correct height safety equipment (harnesses etc.)

All other relevant safety factors specific to the installation and maintenance work to be compliant

with suitable Occupational, Health and Safety Regulations / Codes.

All relevant permits shall be obtained from the regulatory authorities before commencing work to install
the solar hot water system.

All work carried out must be performed by appropriately qualified tradespeople or be suitably supervised
for trades assistant duties.

Every care must be taken to protect and warn occupants of the building and the public from personal
injury which may occur from falling tools, roof materials, fittings or any other hazards of a general nature.

Advise the occupants of any inconvenience which may occur due to disconnection of existing water and
electrical supplies.

The connection, attachment, integration or general association of other equipment or parts which either
directly or indirectly affect the operation or performance of this equipment could void the warranty.

All packaging materials must be removed from the water heater prior to its installation. This includes the
removal of the cardboard base of the carton from the underside of the water heater.
FREEZE PROTECTION
The system has a level of freeze protection designed to guard the system against damage from freeze
conditions. The system must be installed with the full length of the solar hot and solar cold pipes insulated to
offer protection against freeze damage (refer to
conditions occur below 6°C.
The system has NO WARRANTY for freeze damage when installed above 400 metres altitude or if the solar
hot and solar cold pipes are not insulated in accordance with the installation instructions (refer to
Exclusions" on page 47). Note: Warranty against freeze damage applies only to systems installed in
Australia.
INSTALLATION STANDARDS
The installation must comply with the requirements of AS/NZS 3500.4, AS/NZS 3000 and all local codes and
regulatory authority requirements. In New Zealand, the installation must conform with Clause G12 of the New
Zealand Building Code.
"Warning: Plumber Be Aware"
20
on page 33). Freeze
"Warranty