Ford Explorer 2010 Owner's Manual page 565

Lights
To adjust the headlamps:
1. Park your vehicle on a level surface about 25 feet (7.6 meters) away
from a vertical plain surface (3). Check your headlamp alignment at
night or in a dark area so that you can see the headlamp beam pattern.
• (1) 8 feet (2.4 m)
• (2) Center height of lamp to
ground
• (3) 25 feet (7.6 m)
• (4) Horizontal reference line
2. The center of the headlamp has a
3.0 mm circle on the lens. Measure
the height from the center of your
headlamp to the ground (2) and
mark an 8 foot (2.4 m) long
horizontal line on the plain surface (1) at this height (masking tape
works well).
3. Turn on the low beam headlamps.
The brightest part of the light
should be below the horizontal line
(4). If it is above the line the
headlamp will need to be adjusted.
4. Open the hood.
5. Locate the vertical adjuster for
each headlamp. Adjust the aim by
turning the adjuster control either
clockwise (to adjust down) or
counterclockwise (to adjust up).
Note: Use a 4 mm socket or box
wrench to turn the vertical adjuster
control.
HORIZONTAL AIMING IS NOT
REQUIRED FOR THIS VEHICLE
AND IS NON-ADJUSTABLE.
109
2010 Explorer (exp)
Owners Guide, 2nd Printing
USA (fus)