Chapter 13 Qos Commands; Qos; Qos Dscp - TP-Link TL-SG2216 Reference Manual

Chapter 13 QoS Commands

QoS (Quality of Service) function is used to optimize the network performance. It provides you with
network service experience of a better quality.

qos

Description
The qos command is used to configure CoS (Class of Service) based on port.
To return to the default configuration, please use no qos command.
Syntax
qos cos-id
no qos
Parameter
cos-id — — The priority of port. It ranges from 0 to 7, which represent
CoS0-CoS7 respectively. By default, the priority is 0.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
User Guidelines
Port priority is one property of the port. When the port priority is specified, the
data will be classified into the egress queue based on the CoS value of the
ingress port and the mapping relation between the CoS and TC in IEEE 802.1P.
Example
Configure the priority of port 5 as 3:
TL-SG2424(config)# interface gigabitEthernet 1/0/5
TL-SG2424(config-if)# qos 3

qos dscp

Description
The qos dscp command is used to enable the mapping relation between DSCP
Priority and CoS value. To disable the mapping relation, please use no qos
dscp command.
79