TP-Link TL-SG2216 Reference Manual page 16

The following table gives detailed information about the Accessing path, Prompt of each mode and
how to exit the current mode and access the next mode.
Accessing
Mode
Path
Primary
User EXEC
once
connected with the
Mode
switch.
Use the
Privileged command to enter
this mode
EXEC Mode
User EXEC mode.
Use the configure
command to enter
this mode
Privileged
Global
mode.
Configuration
Mode
Use the interface
type
command to enter
Interface
this mode
Configuration
Global
Mode
Configuration
mode.
Use
vlan-list command
VLAN
to enter this mode
Configuration
from
Mode
Configuration
mode.
Note:
1. The user is automatically in User EXEC Mode after the connection between the PC and the
switch is established by a telnet connection.
mode
it is
TL-SG2424>
enable
TL- SG2424#
from
from
EXEC
T L- SG2424 (config)#
number
TL-SG2424 (config-if)#
from
TL-SG2424(config-if-range)#
the vlan
TL-SG2424 (config-vlan)#
Global
Prompt
Use
disconnect the switch.
Use the enable command to
access Privileged EXEC mode.
Enter the disable or the exit
command to return to User EXEC
mode.
Enter
access Global Configuration mode.
Use the exit or the end command
or press Ctrl+Z to return to
Privileged EXEC mode.
Use the interface gigabitEthernet
port
gigabitEthernet port-list command
to access interface Configuration
mode.
Use the vlan vlan-list to access
VLAN Configuration mode.
Use the end command or press
Ctrl+Z to return to Privileged EXEC
mode.
Enter exit command or the #
or
command to return to Global
Configuration mode.
A port number must be specified in
the interface command.
Use the end command or press
Ctrl+Z to return to Privileged EXEC
mode.
Enter the exit command or the #
command to return to Global
configuration mode.
5
Logout or Access the next
mode
the exit command
configure command
or interface
to
to
range