Bandwidth - TP-Link TL-SG2216 Reference Manual

in the network. If the transmission rate of the UL frames exceeds the set
bandwidth, the packets will be automatically discarded to avoid network
broadcast storm.
Syntax
storm-control unicast [rate rate]
no storm-control unicast
Parameter
rate —— Specify the bandwidth for receiving UL-Frame on the port. The
packet traffic exceeding the bandwidth will be discarded. The value of it can be
128k | 256k| 512k|1m | 2m | 4m | 5m | 10m | 20m | 40m | 50m in bps. By default,
the value is "128K".
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Example
Enable the unicast control function for port 5:
TL-SG2424(config)# interface gigabitEthernet 1/0/5
TL-SG2424(config-if)# storm-control unicast

bandwidth

Description
The bandwidth command is used to configure the bandwidth limit for an
Ethernet port. To disable the bandwidth limit, please use no bandwidth
command.
Syntax
bandwidth {[ ingress ingress-rate ] [ egress egress-rate ]}
no bandwidth { all | ingress | egress }
Parameter
ingress-rate — —
1-1024000 for the gigaport.
egress-rate — —
1-1024000 for the gigaport.
Specify the bandwidth for receiving packets. Range:
Specify the bandwidth for sending packets. Range:
73