Securing And Leveling The Appliance - Heatilator Direct Vent Gas Appliance CNXT4236IH Owner's Manual

B. Securing and Leveling the Appliance
WARNING! Risk of Fire! Prevent contact with:
• Sagging or loose insulation
• Insulation backing or plastic
• Framing and other combustible materials
Block openings into the chase to prevent entry of blown-
in insulation. Make sure insulation and other materials
are secured.
DO NOT notch the framing around the appliance
standoffs.
Failure to maintain air space clearance may cause
overheating and fi re.
The diagram shows how to properly position, level, and
secure the appliance (see Figure 9.20). Nailing tabs are
provided to secure the appliance to the framing members.
• Bend out nailing tabs on each side.
• Place the appliance into position.
• Keep nailing tabs fl ush with the framing.
• Level the appliance from side to side and front to
back.
• Shim the appliance as necessary. It is acceptable to use
wood shims underneath the appliance.
• Secure the appliance to the framing by using nails or
screws through the nailing tabs.
• Secure the appliance to the fl oor by inserting two screws
through the pilot holes at the bottom of the appliance.
Heatilator • Caliber CNXT Series • 4047-132 Rev U • 11/08
Nailing Tabs
(both sides)
Figure 9.20 Proper Positioning, Leveling And Securing Of An
Appliance
41