Heatilator Direct Vent Gas Appliance CNXT4236IH Owner's Manual page 40

• Locate heat shield cover plate removed in the fi rst step.
Place the heat shield cover plate on top of heat shield.
Replace four screws to hold this plate in place. See
Figure 9.16.
Figure 9.16 Cover Plate-Replace
• Locate outer shell cover removed in the sixth step
(Figure 9.7). Place the cover on top of appliance. See
Figure 9.17. Replace four screws to hold plate in place.
See Figure 9.18.
Figure 9.17 Place Cover Plate on Top of Appliance
40 Heatilator • Caliber CNXT Series • 4047-132 Rev U • 11/08
Figure 9.18 Screw Cover into Place
• The appliance should look like the one shown in
Figure 9.19 after it has been converted to a rear vent
appliance.
Figure 9.19 Completed Conversion