Table of Contents
Advertisement
Driver Controls
Note: You will need to wait 2 seconds after opening the liftgate to begin
manually closing the power liftgate.
Obstacle detection
The power liftgate system is equipped with an obstacle detection feature.
If the power liftgate is closing, the system is designed to reverse to full
open when it encounters a solid obstacle. Once the obstacle is removed,
the liftgate can be closed under power.
If the power liftgate is opening, the system is designed to stop when it
encounters a solid obstacle. If the liftgate stops below the half open
position, you will need to close and fully latch the liftgate manually.
Normal operation can then be resumed.
Resetting the power liftgate:
The power liftgate may not operate under these conditions.
• a low voltage or dead battery
• disconnected battery
• the liftgate has been left open for more than six (6) hours.
To reset the power liftgate:
1. Manually close and fully latch the liftgate.
2. Power open the liftgate by using the keyfob or overhead console
button.
3. Once the liftgate is fully open, close the liftgate using the keyfob or
overhead console button.
Note: If the power liftgate system is turned <OFF> in the message
center, the system can not be activated with any switches or with the
liftgate handle. The system will need to be turned <ON> for any power
operation to occur.
Liftgate ajar signal
If the liftgate or liftgate glass are not fully latched, you will receive a
"LIFTGATE AJAR" message on the instrument panel. If you see this
message, check both the liftgate glass and liftgate door to insure they are
fully latched.
154
2003 Navigator (nav)
Owners Guide (post-2002-fmt)
USA English (fus)
Advertisement
Table of Contents
