Table of Contents
Advertisement
PILOT
Figure 30.
1.4 IGNITION SYSTEM WIRING
• This gas fireplace is equipped with an electronic igni-
tion system which operates on a 6 volt system.
• This appliance requires 240 VAC to be wired to the
factory installed junction box. Check factory installed
power cord for damage before using .
WARNING
Shock Risk
•
Replace damaged wire with type
105
O
C rated wire.
•
Wire must have high temperature
insulation.
IGNITION MODULE
6VDC
BATTERY PORT
ON/OFF
SWITCH
GAS LINE
CONNECTED TO
BACK OF VALVE
Heat & Glo • SL-550TRSI-AUE • 2079-902 Rev. B • 7/06
FLAME SPARKER/
SENSOR
VALVE
REMOTE
CONTROL
ANT.
ON/OFF
WALL SWITCH
IGNITION
MODULE
(6V)
GROUND
NEUTRAL
THERMOCOUPLE
BLOCK
(CONNECTED TO
BACK OF VALVE)
VALVE
Label all wires prior to disconnection when servic-
ing controls. Wiring errors can cause improper
and dangerous operation. Verify proper operation
after servicing.
HOT
PLUG IN
CAUTION
23
Hide quick links:
Advertisement
Table of Contents
